enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of bicycle parts - Wikipedia

   en.wikipedia.org/wiki/List_of_bicycle_parts

   Chain tensioner: a device to maintain proper chain tension; Chaintug: a device to aid in setting the proper chain tension; Cluster: a bicycle cogset, either a freewheel, or cassette; Cogset: the set of rear sprockets that attaches to the hub on the rear wheel; Cone: holds bearings in place, pressed against the cup; Cotter: pin for attaching ...

3. R-clip - Wikipedia

   en.wikipedia.org/wiki/R-clip

   R-clips are commonly used to secure the ends of round shafts such as axles and clevis pins. The straight leg of the R-clip is pushed into a hole near one end of the shaft until the semicircular "belly" in the middle of the other, bent leg of the R-clip grips one side of the shaft resisting any force removing the R-clip from its hole.

4. Hitch (knot) - Wikipedia

   en.wikipedia.org/wiki/Hitch_(knot)

   A kind of hitch, which is a knot used for attaching rope to a pole or other structure. Pipe hitch: A hitch-type knot used to secure smooth cylindrical objects. Prusik knot: A friction hitch or knot used to put a loop of cord around a rope, applied in climbing, canyoneering, mountaineering, caving, rope rescue, and by arborists. Reverse half hitches

5. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   The clevis is a U-shaped piece that has holes at the end of the prongs to accept the clevis pin. The clevis pin is similar to a bolt, but is either partially threaded or unthreaded with a cross-hole for a split pin. A tang is a piece that is sometimes fitted in the space within the clevis and is held in place by the clevis pin.

6. Master link - Wikipedia

   en.wikipedia.org/wiki/Master_link

   Figure 3: A SRAM Powerlink, joining two ends of a chain. Figure 4: A master link with a slightly raised profile. Note that the embossed arrow should point toward the inside of the chain-loop. Note also the more prominent pin excess. Figure 5: Master link pliers. They fit over the rollers to take the hard work out of link removal.

7. Lanyard - Wikipedia

   en.wikipedia.org/wiki/Lanyard

   A retrieval lanyard is a nylon webbing lanyard used to raise and lower workers into confined spaces, such as storage tanks. An activation lanyard is a lanyard used to fire an artillery piece or arm the fuze on a bomb leaving an aircraft. [5] A deactivation lanyard is a dead man's switch, where pulling a lanyard free will disable a dangerous device.