enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Industrial fan - Wikipedia

   en.wikipedia.org/wiki/Industrial_fan

   Industrial exhausters – This is a relatively inexpensive, medium-duty, steeply inclined flat-bladed fan for exhausting gases, conveying chips, etc. Pre-engineered fans (PE) – A series of fans of varying blade shapes that are usually available in only standard sizes. Because they are pre-engineered these fans may be available with relatively ...

3. Attic fan - Wikipedia

   en.wikipedia.org/wiki/Attic_fan

   An attic fan installed underneath a roof. A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional ...

4. Whole-house fan - Wikipedia

   en.wikipedia.org/wiki/Whole-house_fan

   A whole house fan pulls air out of a building and forces it into the attic space or, in the case of homes without attics, through an opening in the roof or an outside wall. This forces air from the living areas into the attic and out through the gable and/or soffit vents, while at the same time drawing air from the outside into the living areas ...

5. High-volume low-speed fan - Wikipedia

   en.wikipedia.org/wiki/High-volume_low-speed_fan

   A High-volume low-speed fan. A high-volume low-speed (HVLS) fan is a type of mechanical fan greater than 7 feet (2.1 m) in diameter. [1] HVLS fans are generally ceiling fans although some are pole mounted. HVLS fans move slowly and distribute large amounts of air at low rotational speed– hence the name "high volume, low speed."

6. Fan (machine) - Wikipedia

   en.wikipedia.org/wiki/Fan_(machine)

   Domestic extractor fan: Wall- or ceiling-mounted, the domestic extractor fan is employed to remove moisture and stale air from domestic dwellings. Bathroom extractor fans typically utilize a four-inch (100 mm) impeller, while kitchen extractor fans typically use a six-inch (150 mm) impeller as the room is often bigger.

7. Ventilation (architecture) - Wikipedia

   en.wikipedia.org/wiki/Ventilation_(architecture)

   The ventilation rate, for commercial, industrial, and institutional (CII) buildings, is normally expressed by the volumetric flow rate of outdoor air, introduced to the building. The typical units used are cubic feet per minute (CFM) in the imperial system, or liters per second (L/s) in the metric system (even though cubic meter per second is ...