Search results
Results from the WOW.Com Content Network
Rosin used as flux for soldering A flux pen used for electronics rework Multicore solder containing flux Wire freshly coated with solder, held above molten rosin flux. In metallurgy, a flux is a chemical reducing agent, flowing agent, or purifying agent. Fluxes may have more than one function at a time.
RMA flux is formulated to result in a residue which is less corrosive, so that cleaning becomes optional, though usually preferred. R flux is still less active and even less corrosive. Flux performance must be carefully evaluated for best results; a very mild 'no-clean' flux might be perfectly acceptable for production equipment, but not give ...
Flux in the wave soldering process has a primary and a secondary objective. The primary objective is to clean the components that are to be soldered, principally any oxide layers that may have formed. [3] There are two types of flux, corrosive and noncorrosive. Noncorrosive flux requires precleaning and is used when low acidity is required.
The use of ultrasonic soldering is expanding, since it is clean and flux-less in combination with active solders being specified for joining assemblies where either corrosive flux can be trapped or otherwise disrupt operation or contaminate clean production environments or there are dissimilar materials / metals / ceramic / glasses being joined.
Welds produced are sound, uniform, ductile, corrosion resistant and have good impact value. Single pass welds can be made in thick plates with normal equipment. The arc is always covered under a blanket of flux, thus there is no chance of spatter of weld. 50% to 90% of the flux is recoverable, recycled and reused. [7]
In the U.S., trisodium phosphate is an approved flux for use in hard soldering joints in medical-grade copper plumbing. The flux is applied as a concentrated water solution and dissolves copper oxides at the temperature used in copper brazing. Residues are water-soluble and can be rinsed out before plumbing is put into service.
In plumbing systems fluxes are used to keep the mating surfaces clean during soldering operations. The fluxes often consist of corrosive chemicals such as ammonium chloride and zinc chloride in a binder such as petroleum jelly. If too much is applied to the joint, then the excess flux will melt and run down the bore of a vertical tube or pool ...
Many other salts can cause plumbing corrosion, especially if the reactor is hot enough to make highly reactive hydrogen. To date, most research has focused on FLiBe, because lithium and beryllium are reasonably effective moderators and form a eutectic salt mixture with a lower melting point than each of the constituent salts.