Search results
Results from the WOW.Com Content Network
A smog check inspection is performed by a station that has been licensed by the California Bureau of Automotive Repair (BAR). Depending on the situation, the owner may be required to take the vehicle to one of the following types of smog check stations: Test-only station, one that can perform the smog check test, but cannot make repairs.
Stain removal is the process of removing a mark or spot left by one substance on a specific surface like a fabric. A solvent or detergent is generally used to conduct stain removal and many of these are available over the counter.
The Clean Air Act of 1963 (CAA) was passed as an extension of the Air Pollution Control Act of 1955, encouraging the federal government via the United States Public Health Service under the then-Department of Health, Education, and Welfare (HEW) to encourage research and development towards reducing pollution and working with states to establish their own emission reduction programs.
$14.99 at amazon.com. Depending on the brand of windshield wiper fluid used, Burgett says the methanol, ethanol, isopropyl alcohol and glycols, or a combination of these ingredients in the formula ...
Solid film lubricants are paint-like coatings of very fine particles of lubricating pigment blended with a binder and other additives. The lubricant is applied to a substrate by spray, dip or brush methods and, once cured, creates a solid film which repels water, reduces friction and increases the wear life of the substrate to which it has been applied. [1]
Dry lubricants or solid lubricants are materials that, despite being in the solid phase, are able to reduce friction between two surfaces sliding against each other without the need for a liquid oil medium. [1] The two main dry lubricants are graphite and molybdenum disulfide. They offer lubrication at temperatures higher than liquid and oil ...
Test cycles specify the conditions under which the engine or vehicle is operated during the emission test. There are many different test cycles issued by various national and international governments and working groups. [1] Specified parameters in a test cycle include a range of operating temperature, speed, and load. Ideally these should ...
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.