Search results
Results from the WOW.Com Content Network
Watts logo. Watts Water Technologies, Inc. is a company based in the United States that makes valve products for plumbing and heating, such as water pressure regulators and other valves. [1] Watts is one of the largest manufacturers of water valves in the United States. The company was founded by Joseph Watts. [2] It employs about 4,500 ...
The traditional hot water recirculation system uses the existing cold water line as return line from the point of use located farthest from the hot water tank back to the hot water tank. The first of two system types has a pump mounted at the hot water heater while a "normally open" thermostatic control valve gets installed at the farthest ...
Variable speed pumps were replaced with two-speed pumps (each rated at 35,400 US gallons per minute (2.23 m 3 /s) for a discharge pressure head of 865 feet (264 m)), and a flow control valve (adjustable from 22% open to 100% open with a linear flow response) was added to each loop for use in regulating recirculation flow (capable of regulating ...
Reciprocating pump has wide application and to clear the basic idea it is necessary to know the basic parts. The basic parts along with its function; Water reservoir - it is not a part of reciprocating pump, however, it is the main source where from the reciprocating pump takes the water. It may be a source of other fluid as well.
The secondary pump takes the feed water going to the boiler and raises the pressure of the water going in. In a natural circulation boilers, the circulation of water is dependent on the differential pressures caused by the change of density in the water as it is heated. That is to say that as the water is heated and starts turning to steam, the ...
The following diagram shows the relation between the angle of the crankshaft and the delivery rate of a single-acting and double-acting pump. The line shows the average delivery rate of the pump. These fluctuations in pressure and delivery can cause undesired effects such as water hammer and thus are generally mitigated by the installation of ...
Due to the rotation, water is then picked up by the tube and pumped upwards in the hose. The coil pump, as many low lift pumps, is commonly used for irrigation purposes and for drainage of lands. It is currently still used by farmers in Asia. [1] The coil pump was built as an alternative to the Archimedean screw. Unlike the Archimedean screw ...
Single-stage vacuum pumps typically produce vacuum to 35 torr (mm Hg) or 47 millibars (4.7 kPa), and two-stage pumps can produce vacuum to 25 torr, assuming air is being pumped and the ring-liquid is water at 15 °C (59 °F) or less. Dry air and 15 °C sealant-water temperature is the standard performance basis, which most manufacturers use for ...