enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   In CC drivers, the voltage changes while the current stays the same. CC drivers are used when the electrical load of the LED circuit is either unknown or fluctuates, for example, a lighting circuit where a variable number of LED lamp fixtures may be installed. As an LED heats up, its voltage drop decreases (band gap decrease [1]). This can ...

3. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

4. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   The filaments use a rather high voltage, allowing them to work efficiently with mains voltages. Often a simple rectifier and capacitive current limiting are employed to create a low-cost replacement for a traditional light bulb without the complexity of the low voltage, high current converter that single die LEDs need. [60]

5. SMD LED - Wikipedia

   en.wikipedia.org/wiki/SMD_LED

   The light from white LED lamps and LED strip lights is usually provided by industry standard surface-mounted device LEDs (SMD LEDs). [2] Non-SMD types of LED lighting also exist, such as COB (chip on board) and MCOB (multi-COB). Surface-mounted device LED modules are described by the dimensions of the LED package. A single multicolor module may ...

6. 0-10 V lighting control - Wikipedia

   en.wikipedia.org/wiki/0-10_V_lighting_control

   Dimming fluorescent ballasts and dimming LED drivers often use 0–10 V control signals to control dimming functions. In many cases, the dimming range of the power supply or ballast is limited. If the light output can only be dimmed from 100% down to 10%, there must be a switch or relay available to kill power to the system and turn the light ...