Search results
Results from the WOW.Com Content Network
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
A direct-conversion receiver (DCR), also known as a homodyne, synchrodyne, zero intermediate frequency or zero-IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is identical to, or very close to the carrier frequency of the intended signal.
Envelope tracking waveform. Envelope tracking (ET) describes an approach to radio frequency (RF) amplifier design in which the power supply voltage applied to the RF power amplifier is continuously adjusted to ensure that the amplifier is operating at peak efficiency for power required at each instant of transmission.
HackRF One is a wide band software defined radio (SDR) half-duplex transceiver created and manufactured by Great Scott Gadgets. It is able to send and receive signals. Its principal designer, Michael Ossmann, launched a successful Kickstarter campaign in 2014 with a first run of the project called HackRF. [1]
Another reason is the increased portability of a wireless system. With battery-powered radio frequency wireless intercom units, a person can carry a station as they walk around. One of the challenges of a wireless system is the possibility of interference. Radio frequency wireless systems may get interference from other wireless devices.
A radio-frequency integrated circuit, or RFIC, is an electrical integrated circuit operating in a frequency range suitable for wireless transmission. Applications for RFICs include radar and communications.
An RF module (short for radio-frequency module) is a (usually) small electronic device used to transmit and/or receive radio signals between two devices. In an embedded system it is often desirable to communicate with another device wirelessly .
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...