Search results
Results from the WOW.Com Content Network
The alloy can be reacted with water to form hydrogen gas(H2), aluminum hydroxide and gallium metal. [2] Normally, aluminum does not react with water, since it quickly reacts in air to form a passivation layer of aluminum oxide. AlGa alloy is able to create aluminum nanoparticles for the hydrogen producing reaction.
Electrochemical sources of hydrogen include acids (as may be encountered during pickling, etching, or cleaning), corrosion (typically due to aqueous corrosion or cathodic protection), and electroplating. [1] [2] Hydrogen can be introduced into the metal during manufacturing by the presence of moisture during welding or while the metal is molten.
Metallurgical failure analysis is the process to determine the mechanism that has caused a metal component to fail.It can identify the cause of failure, providing insight into the root cause and potential solutions to prevent similar failures in the future, as well as culpability, which is important in legal cases. [1]
A corrosion inhibitor or anti-corrosive is a chemical compound added to a liquid or gas to decrease the corrosion rate of a metal that comes into contact with the fluid. [1] The effectiveness of a corrosion inhibitor depends on fluid composition and dynamics .
Galvanic corrosion of an aluminium plate occurred when the plate was connected to a mild steel structural support.. Galvanic corrosion occurs when two different metals have physical or electrical contact with each other and are immersed in a common electrolyte, or when the same metal is exposed to electrolyte with different concentrations.
Flow-accelerated corrosion (FAC), also known as flow-assisted corrosion, is a corrosion mechanism in which a normally protective oxide layer on a metal surface dissolves in a fast flowing water. The underlying metal corrodes to re-create the oxide, and thus the metal loss continues.
In true corrosion fatigue, the fatigue-crack-growth rate is enhanced by corrosion; this effect is seen in all three regions of the fatigue-crack growth-rate diagram. The diagram on the left is a schematic of crack-growth rate under true corrosion fatigue; the curve shifts to a lower stress-intensity-factor range in the corrosive environment.
Au 5 Al 2 typically forms at 95% of Au and 5% of Al by mass, its melting point is about 575 °C, which is the lowest among the major gold-aluminum intermetallic compounds. AuAl 2 is a brittle bright-purple compound, with a composition of about 78.5% Au and 21.5% Al by mass.