Ad
related to: buick ignition module symptoms and problemsebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The ignition switch was designed to remove power from the vehicle's airbags when in the Off or Accessory mode. [11] Therefore, this was a safety hazard: If the switch changed from Run to Accessory and the vehicle was involved in an accident, it would no longer have power to release the airbags, and it would be difficult for the driver to steer ...
In 1981, a Delco Electronics ECU was used by several Chevrolet and Buick engines to control their fuel system (a closed-loop carburetor) and ignition system. [10] By 1988, Delco Electronics was the leading producer of engine management systems, producing over 28,000 ECUs per day. [11]
A predecessor system called "Unitized Ignition" was optional on 1972 and 1973 Pontiacs. [citation needed] Most—but not all—HEI systems have the ignition coil mounted in the distributor cap. A control module and magnetic pickup are mounted in the distributor, in place of a conventional ignition system's breaker points and condenser.
This sensor is one of the two most important sensors in modern-day engines, together with the camshaft position sensor. As the fuel injection (diesel engines) or spark ignition (petrol engines) is usually timed from the crank sensor position signal, failing sensor will cause an engine not to start or will cut out while running.
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...
Capacitor discharge ignition (CDI) or thyristor ignition is a type of automotive electronic ignition system which is widely used in outboard motors, motorcycles, lawn mowers, chainsaws, small engines, gas turbine-powered aircraft, and some cars.
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
Ad
related to: buick ignition module symptoms and problemsebay.com has been visited by 1M+ users in the past month