Ads
related to: control cable vs power cord switch for computer display standQuail.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Original IBM power supplies for the PC (model 5150), XT and AT included a line-voltage power switch that extended through the side of the computer case. In a common variant found in tower cases, the line-voltage switch was connected to the power supply with a short cable, allowing it to be mounted apart from the power supply.
This can be avoided by unplugging the appliance or using a power strip and using the switch on the power strip to cut all power to the appliance." [3] Standby power used by older devices can be as high as 10–15 W per device, [4] while a modern HD LCD television may use less than 1 W in standby mode. Some appliances use no energy when turned off.
Cable management is particularly important in powered equipment which must move large distances while tethered to a power source and control cabling. There are several common methods of cable management. With a suspended sliding coil, the cables are coiled like a spring, with each loop of the coil attached to a sliding shoe on a track.
A female 9-pin connector on an IBM compatible personal computer may be a digital RGBI video display output such as MDA, Hercules, CGA, or EGA (rarely VGA or others). Even though these all use the same DE-9 connector, the displays cannot all be interchanged and monitors or video interfaces may be damaged if connected to an incompatible device ...
Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data. [a] An additional cable was used for power, initially frequently AC but later usually connected directly to a DC power supply unit. The controller provided ...
USB OTG defines two roles for devices: OTG A-device and OTG B-device, specifying which side supplies power to the link, and which initially is the host. The OTG A-device is a power supplier, and an OTG B-device is a power consumer. In the default link configuration, the A-device acts as a USB host with the B-device acting as a USB peripheral ...
Stand-alone switched-mode power supply An adjustable switched-mode power supply for laboratory use. A switched-mode power supply (SMPS), also called switching-mode power supply, switch-mode power supply, switched power supply, or simply switcher, is an electronic power supply that incorporates a switching regulator to convert electrical power efficiently.
An SY control cable is a flexible instrumentation electrical cable designed for measuring, control or regulation in the field of process automation. [1] It is a flexible multicore cable , with (class 5) [ which? ] copper conductors and a galvanised steel wire braid (GSWB) for mechanical protection.
Ads
related to: control cable vs power cord switch for computer display standQuail.com has been visited by 10K+ users in the past month