enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   Example: Pipe thread EN 10226 Rp 2 + 1 ⁄ 2 The terminology for the use of G and R originated from Germany ( G for gas , as it was originally designed for use on gas pipes; R for rohr , meaning pipe .)

3. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   The half-angle (between the taper surface and the axis of the pipe) is arctan(1 ⁄ 32) ≈ 1.7899° ≈ 1° 47′. The standard for Nominal Pipe Size (often abbreviated NPS, which should not be confused with the abbreviation NPS for the straight thread form standard) is loosely related to the inside diameter of Schedule 40 series of sizes.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   [1] [2] These fittings are used in plumbing to manipulate the conveyance of fluids such as water for potatory, irrigational, sanitary, and refrigerative purposes, gas, petroleum, liquid waste, or any other liquid or gaseous substances required in domestic or commercial environments, within a system of pipes or tubes, connected by various ...

5. Propane, butane, and LPG container valve connections

   en.wikipedia.org/wiki/Propane,_butane,_and_LPG...

   The iOverlander [2] database maintained by travelers, My LPG [3] and the Facebook group "Cooking Gas Around the World [4]" provide more information about individual sources per country. Much general information about global LPG use and standardization is available from the World LPG Association [ 5 ] and the AEGPL [ 6 ]

6. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16-inch (1.6 mm), so the internal diameter is only "nominal" rather than a controlling dimension. [13]

7. Thread seal tape - Wikipedia

   en.wikipedia.org/wiki/Thread_seal_tape

   The second standard, A-A-58092, [4] is a commercial grade which maintains the thickness requirement of MIL-T-27730A and adds a minimum density of 1.2 g/cm 3. [4] Relevant standards may vary between industries; tape for gas fittings (to UK gas regulations) is required to be thicker than that for water.