Ad
related to: tiger 2 armor thickness measurement chart
Search results
Results from the WOW.Com Content Network
An R.A.C 3.d. document of February 1945 estimated that the British (76.2 mm) QF 17-pounder gun, using armour-piercing discarding sabot shot was theoretically capable of penetrating the front of the Tiger II's turret and nose (lower front hull) at 1,100 and 1,200 yd (1,000 and 1,100 m) respectively although, given the lack of a stated angle ...
The VPAM scale as of 2009 runs from 1 to 14, with 1-5 being soft armor, and 6-14 being hard armor. [1] Tested armor must withstand three hits, spaced 120 mm (4.7 inches) apart, of the designated test threat with no more than 25 mm (0.98 inches) of back-face deformation in order to pass.
The Tiger had 100 mm of armor on the front of the hull and turret, while the sides had 80mm of armor. Armor was weakest on the rear of the turret. Americans and British tank forces first encountered the German Tiger I in North Africa, where it outclassed the British Churchills and American M4 Shermans .
B Tiger II. Notes: Tiger I (Panzer VI E/H, Sd.Kfz. 181) was armed with an 88 mm L/56 gun; Sturmtiger - assault tank based on Tiger I chassis. Armed with 380 mm rocket mortar converted from battle damaged tanks; Tiger II (Panzer VI B, Sd.Kfz. 182, also known as Königstiger) was armed with an 88 mm L/71 gun; Jagdtiger (Sd.Kfz. 186) - Based on ...
The turret had a maximum armor thickness of 279 mm (11.0 in) [4] compared to 185 mm (7.3 in) [5] on that of the German Tiger II, increasing to 305 mm (12.0 in) on the mantlet; and had a traverse speed of 18 degrees per second, taking 20 seconds for a full rotation. The gun was able to elevate 20°+/-10° from horizontal.
By early 1943, a decision was made to install a 128 mm gun on either a Panther or Tiger I chassis as a heavy assault gun. The Panther chassis was considered unsuitable after a wooden mockup of the design was constructed. On 20 October 1943, another wooden mockup was constructed on a Tiger II heavy tank chassis, and presented to Hitler in East ...
Close view of Zimmerit on the turret and hull of Michael Wittmann's Tiger I. Close view of Zimmerit on the corner of a Tiger II Close view of Zimmerit on the glacis of a Tiger II. Zimmerit was a paste-like coating used on mid- and late-war German armored fighting vehicles during World War II.
A Chinese publication lists 30MnCrNiMo "685" steel as the material used in Chinese rolled armor plates, with a Brinell Hardness of HBW 444-514 (thin) / 429-495 (thick). According to the same publication, older vehicles use a 22SiMn2TiB "616" steel with a hardness of HBS ≤ 219.
Ad
related to: tiger 2 armor thickness measurement chart