Search results
Results from the WOW.Com Content Network
Wall studs are framing components in timber or steel-framed walls, that run between the top and bottom plates.It is a fundamental element in frame building. The majority non-masonry buildings rely on wall studs, with wood being the most common and least-expensive material used for studs.
A characteristic of the eastern school is close studding which is a half-timbering style of many studs spaced about the width of the studs apart (for example six-inch studs spaced six inches apart) until the middle of the 16th century and sometimes wider spacing after that time. Close studding was an elite style found mostly on expensive buildings.
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
Timber framing is a general term for building with wooden posts and beams. The term post is the namesake of other general names for timber framing such as post-and-beam, post-and-girt construction and more specific types of timber framing such as Post and lintel, post-frame, post in ground, and ridge-post construction.
The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.
Wood furring strips typically measure 1 x 2 or 1 x 3 inches. They can be laid out perpendicular to studs or joists and nailed to them, or set vertically against an existing wall surface. The spacing between the strips depends on the type of finishing material. Wider spacing is typically used behind the heavy boards that support ceramic tiles.
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
A mud and stud wall in Tumby Woodside, Lincolnshire "Mud and stud" is a similar process to wattle and daub, with a simple frame consisting only of upright studs joined by cross rails at the tops and bottoms. Thin staves of ash were attached, then daubed with a mixture of mud, straw, hair and dung. The style of building was once common in ...