Search results
Results from the WOW.Com Content Network
Double dump valves have two trap-door flap plates which open and close on an alternating cycle. The top gate opens to allow collected material to drop through onto the bottom gate. The top gate then re-closes to prevent air leakage above the valve. The bottom gate then opens to allow material to pass completely through the valve.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
When the handle of a flush toilet with a tank (British, cistern) is turned, a discharge mechanism is activated by means of a rod or chain. The mechanism may be a flapper valve, which is designed to sink more slowly than the water - allowing the water to exit to the toilet bowl below, so that the tank may empty.
The diaphragm technology allows the flush valve to open and let water into the bowl. A main cylinder valve operates up and down. A groove in this cylinder allows water from the main supply to flow through when it is in a mid position. The valve is shut off at both its top and bottom positions.
This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...
Duckbill exhaust valve for Draeger twin hose regulator. A duckbill valve is a check valve, usually manufactured from rubber or synthetic elastomer, and has two or more flaps, usually shaped like the beak of a duck. [1] It is commonly used in medical applications to prevent contamination due to backflow. A cross-section diagram of a Duckbill valve.
The toilet has two buttons on the cistern rather than the single-flush one; one button delivers a lesser amount of water (eg. 3 litres) and the other a greater amount (eg. 6 litres). [7] It also uses a larger 10 cm trapway in the bowl, allowing for water to come out faster and clear the bowl efficiently.
It has a total of 124 collection points, 368 waste inlets, and 13 km of pipe. The system's daily collection capacity for dry waste, biowaste, paper, and recyclable cardboard comes to a combined total of 13 tonnes, and it became operational in 2012. In Bergen, Norway, a system covers most of the city center. [17] [18]