Search results
Results from the WOW.Com Content Network
The ACIS/TVIS System. Acoustic Control Induction System, or ACIS, is an implementation of a variable-length intake manifold system designed by Toyota.. Simply put, the ACIS system uses a single intake air control valve located in the intake to vary the length of the intake tract in order to optimize power and torque, as well as provide better fuel efficiency and reduce intake "roar".
Vacuum interrupter with ceramic housing. In electrical engineering, a vacuum interrupter is a switch which uses electrical contacts in a vacuum. It is the core component of medium-voltage circuit-breakers, generator circuit-breakers, and high-voltage circuit-breakers.
A vacuum delay valve is a valve with a small orifice, which delays a vacuum signal. These are commonly used in automobiles to alter the behavior of vacuum switches , vacuum motors , and other vacuum devices.
A sprytron, also known as vacuum krytron or triggered vacuum switch (TVS), is a vacuum, rather than a gas-filled, version. It is designed for use in environments with high levels of ionizing radiation, which might trigger a gas-filled krytron spuriously. It is also more immune to electromagnetic interference than gas-filled tubes.
Ordinary valves can have many ports and fluid paths. A 2-way valve, for example, has 2 ports; if the valve is open, then the two ports are connected and fluid may flow between the ports; if the valve is closed, then ports are isolated. If the valve is open when the solenoid is not energized, then the valve is termed normally open (N.O.).
It received vacuum (port E on the switch) from the carburetor. The vacuum flowed through the switch to a vacuum solenoid (such as a heat riser, used to restrict exhaust allowing the engine to heat up faster). When the coolant heated to operating temperature the vacuum switch closed off the port (port S on the vacuum switch) turning off the ...
A control valve is a valve used to control fluid flow by varying the size of the flow passage as directed by a signal from a controller. [1] This enables the direct control of flow rate and the consequential control of process quantities such as pressure, temperature, and liquid level.
The normally closed valves will not permit flow from the inlet port of the valve to the outlet port, normally the flow will be permitted only by changing the position of the valve. In general, valves are designated as 2/2 DCV, 3/2 DCV, 5/2 DCV, 5/3 DCV etc., in which the first number indicates number of ports and second number indicates number ...