Search results
Results from the WOW.Com Content Network
A sense amplifier is part of the read circuitry that is used when data is read from the memory; its role is to sense the low power signals from a bitline that represents a data bit (1 or 0) stored in a memory cell, and amplify the small voltage swing to recognizable logic levels so the data can be interpreted properly by logic outside the memory.
Referring to the above diagram, if the op-amp is assumed to be ideal, then the voltage at the inverting (-) input is held equal to the voltage at the non-inverting (+) input as a virtual ground. The input voltage passes a current V in / R 1 {\displaystyle V_{\text{in}}/{R_{1}}} through the resistor producing a compensating current flow through ...
Graph of the input () (blue) and output voltage () (red) of an ideal linear amplifier with a voltage gain of 3 with an arbitrary input signal. At any instant the output voltage is three times the input voltage.
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.
Actuator Sensor Interface (AS-Interface or ASi) is an industrial networking solution (Physical Layer, Data access Method and Protocol) used in PLC, DCS and PC-based automation systems. It is designed for connecting simple field I/O devices (e.g. binary ON/OFF devices such as actuators, sensors, rotary encoders, analog inputs and outputs, push ...
Original IBM power supplies for the PC (model 5150), XT and AT included a line-voltage power switch that extended through the side of the computer case. In a common variant found in tower cases, the line-voltage switch was connected to the power supply with a short cable, allowing it to be mounted apart from the power supply.
This connection forces the op-amp to adjust its output voltage to simply equal the input voltage (V out follows V in so the circuit is named op-amp voltage follower). The impedance of this circuit does not come from any change in voltage, but from the input and output impedances of the op-amp.
A programmable-gain amplifier (PGA) is an electronic amplifier (typically based on an operational amplifier) whose gain can be controlled by external digital or analog signals. The gain can be set from less than 1 V/V to over 100 V/V. [ 1 ] Examples for the external digital signals can be SPI , I²C while the latest PGAs can also be programmed ...