enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

3. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

4. Air gap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Air_gap_(plumbing)

   This "air gap" is visible above the sink as a small cylindrical fixture mounted near the faucet. In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained ...

5. Grease trap - Wikipedia

   en.wikipedia.org/wiki/Grease_trap

   Grease trap sizing is based on the size of the 2- or 3-compartment sink, dishwasher, pot sinks, and mop sinks. Many manufacturers and vendors offer online sizing tools to make these calculations easy. The cumulative flow rates of these devices, as well as overall grease retention capacity (in pounds or kilograms) are considered.

6. Drain (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Drain_(plumbing)

   Pool drain vortex as viewed from above the water at Grange Park wading pool Underwater view of drain, showing vortex-formation phenomenon. A drain is the primary vessel or conduit for unwanted water or waste liquids to flow away, either to a more useful area, funnelled into a receptacle, or run into sewers or stormwater mains as waste discharge to be released or processed.

7. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   In some occasional cases, a sink may have both a potable (drinkable) and a non-potable water supply. Lavatories and water closets normally connect to the water supply by means of a supply , which is a tube, usually of nominal 3/8 in ( United States ) or 10 or 12 mm diameter ( Europe and Middle East ), which connects the water supply to the ...

8. Plug (sanitation) - Wikipedia

   en.wikipedia.org/wiki/Plug_(sanitation)

   Plug for a sink. A plug in sanitation is an object that is used to close a drainage outlet firmly. The insertion of a plug into a drainage outlet allows the container to be filled with water or other fluids. In contrast to screw on caps, plugs are pushed into the hole and are not put over the hole.

9. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Steel pipe is often joined with threaded connections; tapered threads are cut into the end of the pipe, and sealant is applied in the form of thread-sealing compound or thread seal tape (also known as PTFE or Teflon tape) and the pipe is screwed into a threaded fitting with a pipe wrench.