Search results
Results from the WOW.Com Content Network
RAID 0 (also known as a stripe set or striped volume) splits ("stripes") data evenly across two or more disks, without parity information, redundancy, or fault tolerance. Since RAID 0 provides no fault tolerance or redundancy, the failure of one drive will cause the entire array to fail, due to data being striped across all disks.
Fault tolerance uses for representation, in place of , in certain Nested RAID levels (see below for fault tolerance calculation). m {\displaystyle m} is the number of disks in each mirror, rather than the total number of disks.
This makes RAID 0 a poor choice for scenarios requiring data reliability or fault tolerance. RAID 1 consists of data mirroring, without parity or striping. Data is written identically to two or more drives, thereby producing a "mirrored set" of drives.
All implementations of RAID, redundant array of independent disks, except RAID 0, are examples of a fault-tolerant storage device that uses data redundancy. A lockstep fault-tolerant machine uses replicated elements operating in parallel. At any time, all the replications of each element should be in the same state.
RAID stands for redundant array of independent disks (or, formerly, redundant array of inexpensive disks). RAID levels may refer to: Standard RAID levels, all the RAID configurations defined in the Common RAID Disk Drive Format standard, which is maintained by the Storage Networking Industry Association
A parity drive is a hard drive used in a RAID array to provide fault tolerance. For example, RAID 3 uses a parity drive to create a system that is both fault tolerant and, because of data striping, fast. [1] Basically, a single data bit is added to the end of a data block to ensure the number of bits in the message is either odd or even. [2]
Those RAID systems made their way to the consumer market, for users wanting the fault-tolerance of RAID without investing in expensive SCSI drives. Fast consumer drives make it possible to build RAID systems at lower cost than with SCSI, but most ATA RAID controllers lack a dedicated buffer or high-performance XOR hardware for parity calculation.
Multipath access to a RAID using Linux DM Multipath (Legend: "HBA" = Host bus adapter, "SAN" = Storage area network). In computer storage, multipath I/O is a fault-tolerance and performance-enhancement technique that defines more than one physical path between the CPU in a computer system and its mass-storage devices through the buses, controllers, switches, and bridge devices connecting them.