Search results
Results from the WOW.Com Content Network
This is the most common form of end lap and is used most in framing. For a half lap in which the members are parallel, the joint may be known as a half lap splice. This is a splice joint and is an alternative to scarfing when joining shorter members end to end. Both members in an end lap have one shoulder and one cheek each. Use for:
A scarf joint may also be used to fix problems caused when a board is cut too short for the application. The board can be cut in half with a tapered cut yielding a scarf joint. When the joint is glued together, the tapers are slid against each other so that the two sections are no longer in line with each other.
The end of a piece of wood is butted against another piece of wood. This is the simplest and weakest joint. Of those, there is the a) T-butt, b) end-to-end butt, c) Miter butt and d) edge-to-edge butt. Lap joint: The end of a piece of wood is laid over and connected to another piece of wood.
The tenon, formed on the end of a member generally referred to as a rail, fits into a square or rectangular hole cut into the other, corresponding member. The tenon is cut to fit the mortise hole exactly. It usually has shoulders that seat when the joint fully enters the mortise hole. The joint may be glued, pinned, or wedged to lock it in place.
A splice joint is a method of joining two members end to end in woodworking. [1] The splice joint is used when the material being joined is not available in the length required. It is an alternative to other joints such as the butt joint and the scarf joint. Splice joints are stronger than unreinenforced butt joints and have the potential to be ...
When two such edges are brought together and clamped, the sprung edges create greater tension at the ends of the join, which assists in creating a seamless joint. When using a hand plane to perform this operation, two boards are often clamped face to face in the vice and both jointed at once, creating two edges that are mirror images of one ...
There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.
Solid parquet boards with grooves on the near ends. Tongues on the right sides of the boards and grooves on the left sides. The far ends are tongued. Tongue and groove is a method of fitting similar objects together, edge to edge, used mainly with wood, in flooring, parquetry, panelling, and similar constructions. Tongue and groove joints allow ...