Search results
Results from the WOW.Com Content Network
Converting units of temperature differences (also referred to as temperature deltas) is not the same as converting absolute temperature values, and different formulae must be used. To convert a delta temperature from degrees Fahrenheit to degrees Celsius, the formula is {ΔT} °F = 9 / 5 {ΔT} °C.
Temperature; system unit code (alternative) symbol notes conversion to kelvin combinations SI: kelvin: K K [K] K °C (K C) ... degree Celsius °C (C) °C ([°C]+273.15)
The degree Celsius (°C) can refer to a specific temperature on the Celsius scale as well as a unit to indicate a temperature interval (a difference between two temperatures). From 1744 until 1954, 0 °C was defined as the freezing point of water and 100 °C was defined as the boiling point of water, both at a pressure of one standard atmosphere.
to say this: the unit of the T (Temperature) is °C (degrees Celsius) (well it should better say Kelvin, but °C shows it better here). It would be great, if someone could add a good explanation to ISO 31-0 (I just added a short sentence there). Greetings -- 217.84.150.117 01:14, 28 July 2007 (UTC)
The table below lists units supported by {{convert}}. More complete lists are linked for each dimension. For a complete list of all dimensions, see full list of units. {{Convert}} uses unit-codes, which are similar to, but not necessarily exactly the same as, the usual written abbreviation for a given unit. These unit-codes are displayed in ...
134 K, highest-temperature superconductor at ambient pressure, mercury barium calcium copper oxide; 165 K, glass point of supercooled water; 184.0 K (–89.2 °C), coldest air recorded on Earth; 192 K, Debye temperature of ice; 273.15 K (0 °C), melting point of bound water; 273.16 K (0.01 °C), temperature of triple point of water; c. 293 K ...
Although "International Temperature Scale of 1990" has the word "scale" in its title, this is a misnomer that can be misleading. The ITS-90 is not a scale; it is an equipment calibration standard. Temperatures measured with equipment calibrated per ITS-90 may be expressed using any temperature scale such as Celsius, Kelvin, Fahrenheit, or Rankine.
For an exact conversion between degrees Fahrenheit and Celsius, and kelvins of a specific temperature point, the following formulas can be applied. Here, f is the value in degrees Fahrenheit, c the value in degrees Celsius, and k the value in kelvins: f °F to c °C: c = f − 32 / 1.8