Search results
Results from the WOW.Com Content Network
Spill occurs when sound is detected by a microphone not intended to pick it up (for example, the vocals being detected by the microphone for the guitar). [3] Spill is often undesirable in popular music recording, [4] as the combined signals during the mix process can cause phase cancellation and may cause difficulty in processing individual tracks. [2]
Audio feedback from microphones occurs when a microphone is too near a monitor or main speaker and the sound reinforcement system amplifies itself. Audio feedback through a microphone is almost universally regarded as a negative phenomenon, many electric guitarists use guitar feedback as part of their performance. This type of feedback is ...
The video, [7] which was released on 11 March 2015, was made in collaboration with Microsoft, Wlodek Markowicz and Karol Paciorek and featured Microsoft Lumia phones, which were used for the video's bullet time effect, [8] a bus driver singing to the song and dancing to it with others (including Clean Bandit), intermixed with clips of Clean ...
The internal electronic circuitry of an active noise-canceling mic attempts to subtract noise signal from the primary microphone. The circuit may employ passive or active noise canceling techniques to filter out the noise, producing an output signal that has a lower noise floor and a higher signal-to-noise ratio .
Situational circumstances: Sometimes a microphone should not be visible, or having a microphone nearby is not appropriate. In scenes for a movie the microphone may be held above, out of the picture frame. Processing: If the signal is destined to be heavily processed, or mixed down, a different type of input may be required.
This is Trump on stage at a rally, pretending to perform a sex-act on a microphone. Trump appeared to make the gesture on stage at a rally in Milwaukee on November 1 (Fox News/YouTube) “This is ...
A microphone’s sensitivity varies with frequency (as well as with other factors such as environmental conditions) and is therefore normally recorded as several sensitivity values, each for a specific frequency band (see frequency spectrum). A microphone’s sensitivity can also depend on the nature of the sound field it is exposed to.
Recording. The analog signal is transmitted from the input device to an analog-to-digital converter (ADC).; The ADC converts this signal by repeatedly measuring the momentary level of the analog (audio) wave and then assigning a binary number with a given quantity of bits (word length) to each measurement point.