Search results
Results from the WOW.Com Content Network
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...
5.75 in × 3.25 in × 8 in (146.1 mm × 82.55 mm × 203 mm). This smaller form factor, first used in an HDD by Seagate in 1980, was the same size as full-height 51⁄4 -inch-diameter (130 mm) FDD, 3.25-inches high. This is twice as high as "half height"; i.e., 1.63 in (41.4 mm). Most desktop models of drives for optical 120 mm disks (DVD, CD ...
The major minus pitch technique also works for inch-based threads, but you must first calculate the pitch by converting the fraction of threads-per-inch (TPI) into a decimal. For example, a screw with a pitch of 1/20 in (20 threads per inch) has a pitch of 0.050 in and a 1 ⁄ 13 in pitch (13 threads per inch) has a pitch of 0.077 in.
Metric (SI) units. 25.4 mm. A fire hydrant marked as 3-inch. The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to translate ...
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
The Reagan administration made Letter-size paper the norm for US federal forms in the early 1980s; previously, the smaller "official" Government Letter size, 8 by 10.5 inches (203.2 by 266.7 mm) (aspect ratio: 1.3125), was used in government, while 8.5-by-11-inch (215.9 by 279.4 mm) paper was standard in most other offices. [2]
The column inch size for advertisements that spread over more than one column is determined by multiplying the number of inches high by number of columns. For example, an advertisement that is 3 columns wide by 6 inches high takes up 18 column inches (3 columns wide multiplied by 6 inches high).