Ads
related to: do i need a preamp with my receiver to work
Search results
Results from the WOW.Com Content Network
With instrument amplifiers, the preamp is often designed to produce overdrive or distortion effects. A stand-alone unit for use in live music and recording studio applications. As part of a stand-alone channel strip or channel strip built into an audio mixing desk. A masthead amplifier used with television receiver antenna or a satellite ...
Marantz 2050L AM/FM stereo tuner (USA; 1978-1980) [1]. In electronics and radio, a tuner is a type of receiver subsystem that receives RF transmissions, such as AM or FM broadcasts, and converts the selected carrier frequency into a form suitable for further processing or output, such as to an amplifier or loudspeaker.
Most phonograph cartridges also have a low output level and require a preamp; typically, a home stereo integrated amplifier or receiver will have a special phono input. This input passes the signal through a phono preamp, which applies RIAA equalization to the signal as well as boosting it to line level.
A line-level attenuator has lower power handling, such as a 1/2-watt potentiometer or voltage divider and controls preamp level signals, whereas a power attenuator has higher power handling capability, such as 10 watts or more, and is used between the power amplifier and the speaker. Power attenuator (guitar) Guitar amplifier
Circuit of a very simple preselector. For any one frequency, using a larger tuning coil results in a narrower bandwidth, i.e. greater rejection of out-of-tune signals.. A preselector is a name for an electronic device that connects between a radio antenna and a radio receiver.
An audio/video receiver (AVR) or a stereo receiver is a consumer electronics component used in a home theater or hi-fi system. Its purpose is to receive audio and video signals from a number of sources, and to process them and provide power amplifiers to drive loudspeakers , and/or route the video to displays such as a television , monitor or ...
The hearing aid comes in two rechargeable styles—behind-the-ear with a small receiver attached to a thin wire that sits in your ear canal or behind-the-ear with the receiver resting over the top ...
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...
Ads
related to: do i need a preamp with my receiver to work