Search results
Results from the WOW.Com Content Network
A short antenna pole next to a house Multiple Yagi TV aerials. Antennas are commonly placed on rooftops and sometimes in attics. Placing an antenna indoors significantly attenuates the level of the available signal. [19] [20] Directional antennas must be pointed at the transmitter they are receiving; in most cases great accuracy is not needed ...
An indoor antenna is a type of radio or TV antenna placed indoors, as opposed to being mounted on the roof. They are usually considered a simple and cheap solution to receive transmissions. An indoor antenna is prone to picking up electrical noise, but digital broadcasts are resistant to this noise.
Corner reflector UHF TV antenna from 1954 with bowtie dipole driven element. A corner reflector antenna is a type of directional antenna used at VHF and UHF frequencies. [1] [2] It was invented by John D. Kraus in 1938. [3] [4] It consists of a dipole driven element mounted in front of two flat rectangular reflecting screens joined at an angle ...
A batwing or super turnstile antenna is a broadcasting antenna used at VHF and UHF frequencies, named for its distinctive shape resembling a bat wing or bow tie. Stacked arrays of batwing antennas are used as television broadcasting antennas due to their omnidirectional characteristics. [1] Batwing antennas generate a horizontally polarized signal.
Analog passthrough is a feature found on some digital-to-analog television converter boxes.Boxes without the analog passthrough feature only allow older, analog-only TVs to view digital TV.
The 5.5 GHz cantenna dimensions are almost perfect in that they make a good fit for the standard TV satellite dish. The resulting setup is a low-cost high-quality high-gain antenna. [6] Such setups are widely used in wireless community networks for long-distance Wi-Fi links. Cantennas may be used with other RF devices such as wireless security ...
Small rhombic UHF television antenna from 1952. Its broad bandwidth allowed it to cover the 470 to 890 MHz UHF television band. A rhombic antenna is made of four sections of wire suspended parallel to the ground in a diamond or "rhombus" shape. Each of the four sides is the same length – about a quarter-wavelength to one wavelength per ...
The system consists of a master antenna and a matching transformer to match the balanced antenna with unbalanced cable and amplifiers. [5] Most antennas have an impedance of around 300 Ω. To convert it to 75 Ω, a matching transformer (or balun) is used. For trunk line isolation, a resistive inductive device known as a splitter is used.