Search results
Results from the WOW.Com Content Network
On some military vessels, such as US naval vessels, enlisted personnel below E-7 board the ship at the afterbrow; officers and CPO/SCPO/MCPO board the ship at the brow. [10] aftercastle. Also sterncastle. A stern structure behind the mizzenmast and above the transom on large sailing ships, much larger but less common than a forecastle.
Ships with cranes or other cargo handling equipment on-board are also termed geared vessels. As container ships usually have no on-board cranes or other mechanism to load or unload their cargo, they are therefore dependent on dockside container cranes to load and unload. However lift-on/lift-off vessels can load and unload their own cargo ...
Outboard: attached outside the ship. [20] Port: the left side of the ship, when facing forward (opposite of "starboard"). [1] Starboard: the right side of the ship, when facing forward (opposite of "port"). [1] Stern: the rear of a ship (opposite of "bow"). [1] Topside: the top portion of the outer surface of a ship on each side above the ...
Glossary of nautical terms may refer to: Glossary of nautical terms (A–L) Glossary of nautical terms (M–Z) This page was last edited on 21 December 2024 ...
3. Farther from the hull of a ship; e.g. "the larger boat was tied up alongside the ship outboard of the smaller boat". 4. Farther from the pier or shore; e.g. "the tanker and cargo ship were tied up at the pier alongside one another with the tanker outboard of the cargo ship". 5. An outboard motor. 6. A vessel fitted with an outboard motor.
The yard exists to allow square sails to be set to drive the ship. The top edge of the sail is 'bent on' (attached) to the yard semi-permanently. Clewlines and buntlines are led along the yard and from there to the mast and down to the deck. These allow the bottom of the sail to be hoisted up to the yard, so the sail is effectively folded in two.
When the ship arrives the cargo is then taken from the warehouse to the quay and then lifted on board by either the ship's gear (derricks or cranes) or by the dockside cranes. The discharge of the ship is the reverse of the loading operation. Loading and discharging by breakbulk is labour-intensive.
A "clean bill of lading" (aka "on-board bill of lading") is used when there is full compliance with no discrepancies between the description filed by the shipper and the actual goods shipped. A clean bill of lading indicates that the goods have been properly loaded onboard the carrier's ship in accordance with the contract.