enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of LED failure modes - Wikipedia

   en.wikipedia.org/wiki/List_of_LED_failure_modes

   Reverse bias: Although the LED is based on a diode junction and is nominally a rectifier, the reverse-breakdown mode for some types can occur at very low voltages and essentially any excess reverse bias can cause immediate degradation, and may lead to vastly accelerated failure. 5 V is a typical maximum reverse bias voltage specification for ...

3. LED circuit - Wikipedia

   en.wikipedia.org/wiki/LED_circuit

   Simple LED (Light Emitting Diode) circuit diagram. In electronics, an LED circuit or LED driver is an electrical circuit used to power a light-emitting diode (LED). The circuit must provide sufficient current to light the LED at the required brightness, but must limit the current to prevent damaging the LED.

4. LED lamp - Wikipedia

   en.wikipedia.org/wiki/LED_lamp

   A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...

5. 5 Inexpensive Car Accessories That’ll Make Your Car Safer ...

   www.aol.com/5-inexpensive-car-accessories-ll...

   Backup Camera System. ... “Headlights that shine brighter (as long as they’re aimed properly) like LED bulbs” can make a huge difference in nighttime visibility, Pyle noted. This can help ...

6. Light-emitting diode - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode

   No current flows and no light is emitted if voltage is applied in the reverse direction. If the reverse voltage exceeds the breakdown voltage, which is typically about five volts, a large current flows and the LED will be damaged. If the reverse current is sufficiently limited to avoid damage, the reverse-conducting LED is a useful noise diode.

7. Light-emitting diode physics - Wikipedia

   en.wikipedia.org/wiki/Light-emitting_diode_physics

   An LED begins to emit light when more than 2 or 3 volts is applied in the forward direction. The reverse bias region uses a different vertical scale from the forward bias region to show that the leakage current is nearly constant with voltage until breakdown occurs. In forward bias, the current starts small but increases exponentially with voltage.