enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Buckling - Wikipedia

    en.wikipedia.org/wiki/Buckling

    Buckling may occur even though the stresses that develop in the structure are well below those needed to cause failure in the material of which the structure is composed. . Further loading may cause significant and somewhat unpredictable deformations, possibly leading to complete loss of the member's load-carrying capac

  3. Deformation (engineering) - Wikipedia

    en.wikipedia.org/wiki/Deformation_(engineering)

    This is not true since the actual area will decrease while deforming due to elastic and plastic deformation. The curve based on the original cross-section and gauge length is called the engineering stress–strain curve , while the curve based on the instantaneous cross-section area and length is called the true stress–strain curve .

  4. List of Gravity Falls episodes - Wikipedia

    en.wikipedia.org/wiki/List_of_Gravity_Falls_episodes

    Disney commissioned Hirsch to create an eleven-minute low-budget animated pilot [2] for Gravity Falls which he later described as "a short version of Tourist Trapped". [9] On December 9, 2010, it was announced that Disney Channel had greenlit Gravity Falls for a full series based on the pilot, which was originally slated to premiere in spring ...

  5. Strength of materials - Wikipedia

    en.wikipedia.org/wiki/Strength_of_materials

    However, structures loaded in compression are subject to additional failure modes, such as buckling, that are dependent on the member's geometry. Tensile stress is the stress state caused by an applied load that tends to elongate the material along the axis of the applied load, in other words, the stress caused by pulling the material.

  6. Deflection (engineering) - Wikipedia

    en.wikipedia.org/wiki/Deflection_(engineering)

    The deflection at any point, , along the span of a center loaded simply supported beam can be calculated using: [1] = for The special case of elastic deflection at the midpoint C of a beam, loaded at its center, supported by two simple supports is then given by: [ 1 ] δ C = F L 3 48 E I {\displaystyle \delta _{C}={\frac {FL^{3}}{48EI}}} where

  7. Compression member - Wikipedia

    en.wikipedia.org/wiki/Compression_member

    A compression member is a structural element that primarily resists forces, which act to shorten or compress the member along its length. Commonly found in engineering and architectural structures, such as columns , struts , and braces, compression members are designed to withstand loads that push or press on them without buckling or failing.

  8. Vitamin D may not prevent fractures or falls in older adults ...

    www.aol.com/vitamin-d-may-not-prevent-102300100.html

    Vitamin D supplements may have no bearing on the severity of injuries from falls in postmenopausal women and older men, according to a new draft recommendation. Vitamin D may not prevent fractures ...

  9. Deformation mechanism - Wikipedia

    en.wikipedia.org/wiki/Deformation_mechanism

    In geology and materials science, a deformation mechanism is a process occurring at a microscopic scale that is responsible for deformation: changes in a material's internal structure, shape and volume. [1] [2] The process involves planar discontinuity and/or displacement of atoms from their original position within a crystal lattice structure.