Search results
Results from the WOW.Com Content Network
In 2014, he claims to have invented a forced reset trigger specifically for the AR-15 platform, subsequently acquiring a patent for it in 2015. According to Graves, he later licensed his patented technology to two well-known manufacturers of forced reset triggers.
Firearms use triggers to initiate the firing of a cartridge seated within the gun barrel chamber.This is accomplished by actuating a striking device through a combination of mainspring (which stores elastic energy), a trap mechanism that can hold the spring under tension, an intermediate mechanism to transmit the kinetic energy from the spring releasing, and a firing pin to eventually strike ...
A trigger disconnector captures the hammer in the cocked position after a shot has been fired, even if the trigger is held to the rear as the gun cycles. This ensures the gun can only fire in the semi-automatic mode, as the trigger needs to be released to 'reset' and have the disconnector release the hammer back to the trigger sear.
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
A disassembled Mauser action showing a partially disassembled receiver and bolt. In firearms terminology and law, the firearm frame or receiver is the part of a firearm which integrates other components by providing housing for internal action components such as the hammer, bolt or breechblock, firing pin and extractor, and has threaded interfaces for externally attaching ("receiving ...
The AR-15 uses an L-type flip, aperture rear sight and it is adjustable with two settings, 0 to 300 meters and 300 to 400 meters. [16] The front sight is a post adjustable for elevation. The rear sight can be adjusted for windage. The sights can be adjusted with a bullet tip or pointed tool. The AR-15 can also mount a scope on the carrying handle.
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.