Search results
Results from the WOW.Com Content Network
Chamber length sleeves are restricted in its overall length, where a short cartridge is used with a long parent cartridge. The sleeve is rifled up to the end of the sleeve. Since most cartridge cases are only about 5 cm (2.0 in) long, this provides a limited power advantage.
This allows for the cartridge to be longer than the standardized 2.260" SAAMI maximum overall length. These cartridges can be safely loaded to a length that has the ogive portion of the bullet just touching the rifle's lands. Many competitive shooters will make these cartridges 0.005" less than the truly maximum allowable overall length, for ...
Headspace positioning of rimless, rimmed, belted and straight cartridges Several different rimmed, .22 rimfire cartridges, which have a uniform forward diameter, and which have headspace on the rim, allowing any length of cartridge shorter than the maximum size to be used in the same firearm Firearms chambered for tapered rimmed cartridges like this .303 British cannot safely fire shorter ...
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
When the firearm is out-of-battery, the round is not fully chambered, or the bolt face is not against the rear of the cartridge, and if the round is fired in this situation, the case will fail, causing high-pressure hot gases, bits of burning propellant, and fragments of the casing itself to be thrown at high speed from the firearm.
The delta L problem (ΔL problem) refers to certain firearm chambers and the incompatibility of some ammunition made for that chamber. ΔL is a Commission Internationale Permanente (C.I.P.) geometric dimensioning and tolerancing definition for cartridge cases that are longer than the chamber they have to fit in. "Delta L" essentially means "difference in length".
Crimping affects the overall length of the cartridge, and thus cannot be used on cartridges which headspace on the case mouth. This can be a problem for magnum revolvers or rifles which simultaneously chamber more than one round of ammunition, as the recoil from the firing successive rounds can loosen the bullets in the remaining cartridges ...
The .375 Viking bullet had an overall length of 70 mm (2.756 in) and derived its anticipated low drag from a radical LD Haack or Sears-Haack profile in the bullet's nose area. Rifles chambered for this wildcat cartridge, with a cartridge overall length of 119 mm (4.685 in), were to have been equipped with custom made 762 mm (30 in) long 203 mm ...