Search results
Results from the WOW.Com Content Network
In radio communications, single-sideband modulation (SSB) or single-sideband suppressed-carrier modulation (SSB-SC) is a type of modulation used to transmit information, such as an audio signal, by radio waves. A refinement of amplitude modulation, it uses transmitter power and bandwidth more efficiently.
The power of an AM radio signal plotted against frequency. fc is the carrier frequency, fm is the maximum modulation frequency. In radio communications, a sideband is a band of frequencies higher than or lower than the carrier frequency, that are the result of the modulation process. The sidebands carry the information transmitted by the radio ...
Most amateur digital modes are transmitted by inserting audio into the microphone input of a radio and using an analog scheme, such as amplitude modulation (AM), frequency modulation (FM), or single-sideband modulation (SSB). Amateur teleprinting over radio (AMTOR) D-STAR (Digital Data) a high speed (128 kbit/s), data-only mode.
Categorization for signal modulation based on data and carrier types. In electronics and telecommunications, modulation is the process of varying one or more properties of a periodic waveform, called the carrier signal, with a separate signal called the modulation signal that typically contains information to be transmitted. [1]
An emission designation is of the form BBBB 123 45, where BBBB is the bandwidth of the signal, 1 is a letter indicating the type of modulation used of the main carrier (not including any subcarriers which is why FM stereo is F8E and not D8E), 2 is a digit representing the type of modulating signal again of the main carrier, 3 is a letter ...
The frequency spectrum of a typical radio signal from an AM or FM radio transmitter. The horizontal axis is frequency; the vertical axis is signal amplitude or power. It consists of a signal (C) at the carrier wave frequency f C, with the modulation contained in narrow frequency bands called sidebands (SB) just above and below the carrier.
SSB, or SSB-AM single-sideband full carrier modulation, is very similar to single-sideband suppressed carrier modulation (SSB-SC). It is used where it is necessary to receive the audio on an AM receiver, while using less bandwidth than with double sideband AM. Due to high distortion, it is seldom used.
A drawback of standard SSB modulation is the generation of large envelope overshoots well above the average envelope level for a sinusoidal tone (even when the audio signal is peak-limited). In combination with RF amplifiers with non-linear properties this causes severe distortions of the transmitted audio signal.