Search results
Results from the WOW.Com Content Network
Like other electrical switches, RF and microwave switches provide different configurations for many different applications. Below is a list of typical switch configurations and usage: Single pole, double throw (SPDT or 1:2) switches route signals from one input to two output paths. Single pole double throw (SPDT) switch from Agilent Technologies
The prior art includes an RF MEMS frequency tunable fractal antenna for the 0.1–6 GHz frequency range, [18] and the actual integration of RF MEMS switches on a self-similar Sierpinski gasket antenna to increase its number of resonant frequencies, extending its range to 8 GHz, 14 GHz and 25 GHz, [19] [20] an RF MEMS radiation pattern ...
Basic automatic frequency control in a radio receiver. У = RF amplifier stages, Д = frequency discriminator stage. In radio equipment, Automatic Frequency Control (AFC), also called Automatic Fine Tuning (AFT), is a method or circuit to automatically keep a resonant circuit tuned to the frequency of an incoming radio signal.
On–off keying (OOK) denotes the simplest form of amplitude-shift keying (ASK) modulation that represents digital data as the presence or absence of a carrier wave. [1] In its simplest form, the presence of a carrier for a specific duration represents a binary one, while its absence for the same duration represents a binary zero.
SCPI was defined as an additional layer on top of the IEEE 488.2-1987 specification "Standard Codes, Formats, Protocols, and Common Commands". [4] The standard specifies a common syntax, command structure, and data formats, to be used with all instruments.
A wireless site survey, sometimes called an RF (Radio Frequency) site survey or wireless survey, is the process of planning and designing a wireless network, to provide a wireless solution that will deliver the required wireless coverage, data rates, network capacity, roaming capability and quality of service (QoS). [1]
A Butler matrix is a beamforming network used to feed a phased array of antenna elements.Its purpose is to control the direction of a beam, or beams, of radio transmission. ...
An RF receiver module receives the modulated RF signal, and demodulates it. There are two types of RF receiver modules: superheterodyne receivers and superregenerative receivers. Superregenerative modules are usually low cost and low power designs using a series of amplifiers to extract modulated data from a carrier wave.