enow.com Web Search

  1. Ads

    related to: high pressure misting pumps 800-1000 psi 40

Search results

  1. Results from the WOW.Com Content Network
  2. Water jet cutter - Wikipedia

    en.wikipedia.org/wiki/Water_jet_cutter

    Most high-pressure pumps at this time, though, operated around 500–800 psi (3.4–5.5 MPa). High-pressure systems were further shaped by the aviation, automotive, and oil industries. Aircraft manufacturers such as Boeing developed seals for hydraulically boosted control systems in the 1940s, [ 14 ] while automotive designers followed similar ...

  3. Piston pump - Wikipedia

    en.wikipedia.org/wiki/Piston_pump

    Piston pump compared to a plunger pump. A piston pump is a type of positive displacement pump where the high-pressure seal reciprocates with the piston. [1] Piston pumps can be used to move liquids or compress gases. They can operate over a wide range of pressures. High pressure operation can be achieved without adversely affecting flow rate.

  4. Plunger pump - Wikipedia

    en.wikipedia.org/wiki/Plunger_pump

    A plunger pump is a type of positive displacement pump where the high-pressure seal is stationary and a smooth cylindrical plunger slides through the seal. This makes them different from piston pumps and allows them to be used at higher pressures. This type of pump is often used to transfer municipal and industrial sewage. [1] [2]

  5. Turbopump - Wikipedia

    en.wikipedia.org/wiki/Turbopump

    A turbopump is a propellant pump with two main components: a rotodynamic pump and a driving gas turbine, usually both mounted on the same shaft, or sometimes geared together. They were initially developed in Germany in the early 1940s. The purpose of a turbopump is to produce a high-pressure fluid for feeding a combustion chamber or other use ...

  6. Hydraulic accumulator - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_accumulator

    As the volume of the compressed gas changes, the pressure of the gas (and the pressure on the fluid) changes inversely. For low pressure water system use the water usually fills a rubber bladder within the tank (pictured), preventing contact with the tank which would otherwise need to be corrosion resistant.

  7. List of pipeline accidents in the United States in the 1980s

    en.wikipedia.org/wiki/List_of_pipeline_accidents...

    October 9 – A 2-inch compression coupling located on the upstream side of a gas meter set assembly in the boiler room of the Simon Kenton High School in Independence, Kentucky, pulled out of its connection with a 2-inch gas service line. Natural gas at 165-psig pressure escaped through the 2-inch opening and, seconds later, exploded and burned.

  1. Ads

    related to: high pressure misting pumps 800-1000 psi 40