Search results
Results from the WOW.Com Content Network
A cylinder with longitudinal draft Profile view of a drafted cylinder with the draft dimension. In engineering, draft is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). Consider the fabrication of a hollow plastic box, without lid.
A diameter tape (D-tape) is a measuring tape used to estimate the diameter of a cylinder object, typically the stem of a tree or pipe. A diameter tape has either metric or imperial measurements reduced by the value of π. This means the tape measures the diameter of the object. It is assumed that the cylinder object is a perfect circle.
Girard form class is a form quotient calculated as the ratio of diameter inside bark at the top of the first 16 foot log to the diameter outside bark at breast height ().Its purpose is to estimate board-foot volume of whole trees from measurement of DBH, estimation of the number of logs, and estimation of the taper of the first log, based on the general relationships identified between the ...
Tree taper is the degree to which a tree's stem or bole decreases in diameter as a function of height above ground. Within Forestry and for the purposes of timber production, trees with a high degree of taper are said to have poor form, while those with low taper have good form. The opposite is the case for open-grown amenity trees.
To calculate trunk volume, the tree is subdivided into a series of segments with the successive diameters being the bottom and top of each segment and segment length being equal to the difference in height between the lower and upper diameters, or if the trunk is not vertical, the segment length can be calculated using the limb length formula ...
The aim of a measurement is to measure the surface on which the dial gauge or spirit level is placed horizontally. For example, to measure the angle of a wedge, the wedge is placed on a horizontal table. The sine bar is placed over the inclined surface of the wedge.
A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.
Feeler gauge set (25 pieces, 0.03~1.0 mm measurement range) Measuring the valve clearance of a DOHC engine, between camshaft and tappet (here: 0.004 in ≈ 0.10 mm). A feeler gauge is a tool used to measure gap widths. Feeler gauges are mostly used in engineering to measure the clearance between two parts. [1]