enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Miter saw - Wikipedia

   en.wikipedia.org/wiki/Miter_saw

   A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...

3. Delta Machinery - Wikipedia

   en.wikipedia.org/wiki/Delta_Machinery

   In 1966, Rockwell invented the world's first power miter saw. In 1981, Rockwell's power tool group was acquired by Pentair and re-branded Delta Machinery . In 2004, Pentair's Tools group was acquired by Black & Decker .

4. Miter clamp - Wikipedia

   en.wikipedia.org/wiki/Miter_clamp

   [citation needed] The screws go under the frame (work-piece) to be held, and the bit clamps down on the lower-edge of the frame. [citation needed] Recent designs are more complicated; a rigid body holds one fixed and one moveable jaw activated by a cam. [citation needed] An example of newer clamps is Jim Chestnut's Clam Clamp. [8]

5. Radial arm saw - Wikipedia

   en.wikipedia.org/wiki/Radial_arm_saw

   Radial Arm Saw. A radial arm saw is a cutting machine consisting of a circular saw mounted on a sliding horizontal arm. Invented by Raymond DeWalt in 1922, the radial arm saw was the primary tool used for cutting long pieces of stock to length until the introduction of the power miter saw in the 1970s.

6. Circular saw - Wikipedia

   en.wikipedia.org/wiki/Circular_saw

   A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw. A circular saw or a buzz saw, is a power-saw using a toothed or abrasive disc or blade to cut different materials using a rotary motion spinning around an arbor.

7. Table saw - Wikipedia

   en.wikipedia.org/wiki/Table_saw

   Miter gauge: The table has one or two slots (grooves) running from front to back, also parallel to the cutting plane of the blade. These miter slots (or miter grooves) are used to position and guide either a miter gauge (also known as a crosscut fence) or crosscut sled. The miter gauge is usually set to be at 90 degrees to the plane of the ...