Search results
Results from the WOW.Com Content Network
Timber framing (German: Fachwerkbauweise) and "post-and-beam" construction are traditional methods of building with heavy timbers, creating structures using squared-off and carefully fitted and joined timbers with joints secured by large wooden pegs.
Historically a beam is a squared timber, but may also be made of metal, stone, or a combination of wood and metal [1] such as a flitch beam.Beams primarily carry vertical gravitational forces, but they are also used to carry horizontal loads such as those due to earthquake or wind, or in tension to resist rafter thrust or compression (collar beam).
A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts. In that common form it is sometimes referenced as a steel ...
Cellular beam is a further development of the traditional castellated beam. [1] The advantage of the steel beam castellation process is that it increases strength without adding weight, making both versions an inexpensive solution to achieve maximum structural load capacity in building construction .
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
True cruck or full cruck: The blades, straight or curved, extend from a foundation near the ground to the ridge. A full cruck does not need a tie beam and may be called a "full cruck - open" or with a tie beam a "full cruck - closed". [7] Base cruck: The tops of the blades are truncated by the first transverse member such as by a tie beam. [7]
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...