Search results
Results from the WOW.Com Content Network
Open emitter output exposes the emitter as the output. [2] For an NPN open emitter output, the collector is connected to the positive voltage rail, so the emitter outputs a high voltage when the transistor is on and is hi-Z when off. For a PNP open emitter output, the collector is connected to the low voltage supply, so the emitter outputs a ...
Open-emitter buffers connected as wired OR. See also: Diode logic § Active-high OR logic gate. The wired OR connection electrically performs the Boolean logic operation of an OR gate using open emitter or similar inputs (which can be identified by the ⎏ symbol in schematics) connected to a shared output with a pull-down resistor. This gate ...
The value of the supply voltage is chosen so that sufficient current flows through the compensating diodes D1 and D2 and the voltage drop across the common emitter resistor R E is adequate. ECL circuits available on the open market usually operated with logic levels incompatible with other families.
The transistor continuously monitors V diff and adjusts its emitter voltage to equal V in minus the mostly constant V BE (approximately one diode forward voltage drop) by passing the collector current through the emitter resistor R E. As a result, the output voltage follows the input voltage variations from V BE up to V +; hence the name ...
Another common example of the use of decoupling capacitors is across the emitter bias resistor of transistor common emitter amplifiers to prevent the resistor absorbing a portion of the AC output power of the amplifier. Lossy ferrite beads may also be used to isolate or 'island' sections of circuitry. These add a high series impedance (in ...
Emitter bias. When a split supply (dual power supply) is available, this biasing circuit is the most effective. It provides zero bias voltage at the emitter or collector for load. [clarification needed] The negative supply V ee is used to forward-bias the emitter junction through R e. The positive supply V cc is used to reverse-bias the ...
An amplifier circuit, a common-emitter configuration with a voltage-divider bias circuit The common-emitter amplifier is designed so that a small change in voltage ( V in ) changes the small current through the base of the transistor whose current amplification combined with the properties of the circuit means that small swings in V in produce ...
The single PN junction between the emitter and the base gives the device its name. The resistance between B1 and B2 when the emitter is open-circuit is called interbase resistance. The emitter junction is usually located closer to base-2 (B2) than base-1 (B1) so that the device is not symmetrical, because a symmetrical unit does not provide ...