enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. DIN 72552 - Wikipedia

   en.wikipedia.org/wiki/DIN_72552

   DIN 72552 is a DIN standard for labeling the electric terminals in automotive wiring. The most frequently used labels are listed in the table below. ... main terminal ...

3. Battery terminal - Wikipedia

   en.wikipedia.org/wiki/Battery_terminal

   General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.

4. Type 2 connector - Wikipedia

   en.wikipedia.org/wiki/Type_2_connector

   The Type 2 connector system was originally proposed by Mennekes in 2009. The system was later tested and standardized by the German Association of the Automotive Industry (VDA) as VDE-AR-E 2623-2-2, and subsequently recommended by the European Automobile Manufacturers Association (ACEA) in 2011.

5. List of battery sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_battery_sizes

   This battery had two-pin connectors. They were a single ⌀3.2 mm negative pin and a single ⌀4.0 mm positive pin spaced 13.0 mm apart. PP11: 4.5 + 4.5: H: 91.3 L: 65.1 W: 52.4 This battery contained two independent 4.5 V batteries, and had a four-pin connector. 9 V with a center tap was available by wiring in series.

6. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.

7. SAE J1772 - Wikipedia

   en.wikipedia.org/wiki/SAE_J1772

   SAE J1772, also known as a J plug or Type 1 connector after its international standard, IEC 62196 Type 1, is a North American standard for electrical connectors for electric vehicles maintained by SAE International under the formal title "SAE Surface Vehicle Recommended Practice J1772, SAE Electric Vehicle Conductive Charge Coupler".