enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Power brakes - Wikipedia

   en.wikipedia.org/wiki/Power_brakes

   The master cylinder is located behind the driver’s side dashboard mounted on the vacuum booster. The pressure inside of the master cylinder is created by a primary and secondary piston. These are pushed by the output rod of the vacuum booster to compress fluid within its primary and secondary chambers (hydraulic pressure). The hydraulic ...

3. Vacuum servo - Wikipedia

   en.wikipedia.org/wiki/Vacuum_servo

   In the US it is commonly called a brake booster. A vacuum servo, also known as a power booster or power brake unit, uses a vacuum, usually supplied by the engine, to multiply the driver's pedal effort and apply that effort to the master cylinder .

4. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...

5. Sensotronic Brake Control - Wikipedia

   en.wikipedia.org/wiki/Sensotronic_Brake_Control

   Sensotronic Brake Control (SBC) is an electro-hydraulic brake system developed by Daimler and Bosch. In this system, the wheel brake cylinders of a vehicle are operated through a servomechanism, offering precise and responsive braking. The SBC system was first introduced on the R230 SL-class, which was released in Europe in October 2001. [1]

6. Hydraulic brake - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_brake

   The spinning disc brake will be adjacent to the piston with the larger cross-section. Suppose the diameter of the master cylinder is half the diameter of the slave cylinder, so the master cylinder has a cross-section four times smaller. Now, if the piston in the master cylinder is pushed down 40 mm, the slave piston will move 10 mm.

7. S-cam - Wikipedia

   en.wikipedia.org/wiki/S-cam

   It consists of a shaft, usually around 4 to 25 inches long, turned at one end by means of an air-powered brake booster and lever with an S-shaped cam at the wheel end. Turning the shaft pushes the brake shoes against the drum, producing friction. The design allows bulky air cylinders to be located outside of the wheel.