enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Table tennis rubber - Wikipedia

    en.wikipedia.org/wiki/Table_tennis_rubber

    Table tennis rubber is a type of rubber used as covering on a racket in table tennis. [1] Modern table tennis rubber is usually composed of two layers: a layer of foam ("sponge") underneath and a layer of actual rubber on the surface. [2] There are four common types of table tennis rubbers: short pips, long pips, antispin, and inverted. [1]

  3. British Standard Pipe - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Pipe

    British Standard Pipe Parallel Thread Dimensions; British Standard Pipe Taper Thread Dimensions Archived 2017-09-27 at the Wayback Machine; BSP Thread Charts and Diagrams, showing dimensions of tubing and fittings; ISO 7-1:1994; ISO 7-2:2000; ISO 228-1:2000; ISO 228-2:1987; Parallel pipe threads G; Parallel pipe threads PF

  4. Category:Table tennis equipment - Wikipedia

    en.wikipedia.org/wiki/Category:Table_tennis...

    Pages in category "Table tennis equipment" The following 3 pages are in this category, out of 3 total. This list may not reflect recent changes. R. Table tennis racket;

  5. AN thread - Wikipedia

    en.wikipedia.org/wiki/AN_thread

    A 37° flare type end fitting for flexible hose The AN thread (also A-N ) is a particular type of fitting used to connect flexible hoses and rigid metal tubing that carry fluid. It is a US military-derived specification that dates back to World War II and stems from a joint standard agreed upon by the Army Air Corps and Navy, hence AN.

  6. Garden hose - Wikipedia

    en.wikipedia.org/wiki/Garden_hose

    3 ⁄ 4-14NPSH designates female hose ends that mate a hose to a tapered pipe thread without a spigot. The US standard was defined by NFPA 1963, "Standard for Fire Hose Connections", [ 2 ] then later by ANSI-ASME B1.20.7, [ 3 ] which specifies 1 + 1 ⁄ 16 inches (27 mm) diameter straight (non-tapered) thread with a pitch of 11.5 threads per ...

  7. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  8. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 22 ] : 149 [ 19 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...

  9. Table tennis - Wikipedia

    en.wikipedia.org/wiki/Table_tennis

    Diagram of a table tennis table showing the official dimensions The table is 2.74 m (9.0 ft) long, 1.525 m (5.0 ft) wide, and 76 cm (2.5 ft) high with any continuous material so long as the table yields a uniform bounce of about 23 cm (9.1 in) when a standard ball is dropped onto it from a height of 30 cm (11.8 in), or about 77%.