enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Ammonia (data page) - Wikipedia

    en.wikipedia.org/wiki/Ammonia_(data_page)

    Heat capacity, c p, of anhydrous ammonia gas. Uses polynomial obtained from CHERIC. [8] Heat capacity of anhydrous liquid ammonia. Uses polynomial obtained from ...

  3. Ammonia solution - Wikipedia

    en.wikipedia.org/wiki/Ammonia_solution

    Ammonia solutions decrease in density as the concentration of dissolved ammonia increases. At 15.6 °C (60.1 °F), the density of a saturated solution is 0.88 g/ml; it contains 35.6% ammonia by mass, 308 grams of ammonia per litre of solution, and has a molarity of approximately 18 mol /L.

  4. Ammonia - Wikipedia

    en.wikipedia.org/wiki/Ammonia

    The hazards of ammonia solutions depend on the concentration: 'dilute' ammonia solutions are usually 5–10% by weight (< 5.62 mol/L); 'concentrated' solutions are usually prepared at >25% by weight. A 25% (by weight) solution has a density of 0.907 g/cm 3, and a solution that has a lower density will be more concentrated.

  5. Haber process - Wikipedia

    en.wikipedia.org/wiki/Haber_process

    The volume fraction of ammonia in the gas mixture is about 20%. The inert components, especially the noble gases such as argon, should not exceed a certain content in order not to reduce the partial pressure of the reactants too much. To remove the inert gas components, part of the gas is removed and the argon is separated in a gas separation ...

  6. Molar volume - Wikipedia

    en.wikipedia.org/wiki/Molar_volume

    The ideal gas equation can be rearranged to give an expression for the molar volume of an ideal gas: = = Hence, for a given temperature and pressure, the molar volume is the same for all ideal gases and is based on the gas constant: R = 8.314 462 618 153 24 m 3 ⋅Pa⋅K −1 ⋅mol −1, or about 8.205 736 608 095 96 × 10 −5 m 3 ⋅atm⋅K ...

  7. Table of specific heat capacities - Wikipedia

    en.wikipedia.org/wiki/Table_of_specific_heat...

    Note that the especially high molar values, as for paraffin, gasoline, water and ammonia, result from calculating specific heats in terms of moles of molecules. If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol ...

  8. Molar concentration - Wikipedia

    en.wikipedia.org/wiki/Molar_concentration

    Molar concentration or molarity is most commonly expressed in units of moles of solute per litre of solution. [2] For use in broader applications, it is defined as amount of substance of solute per unit volume of solution, or per unit volume available to the species, represented by lowercase c {\displaystyle c} : [ 3 ]

  9. Enthalpy change of solution - Wikipedia

    en.wikipedia.org/wiki/Enthalpy_change_of_solution

    The equilibrium, between the gas as a separate phase and the gas in solution, will by Le Châtelier's principle shift to favour the gas going into solution as the temperature is decreased (decreasing the temperature increases the solubility of a gas). When a saturated solution of a gas is heated, gas comes out of the solution.