Ad
related to: camshaft lobe separation angle effects
Search results
Results from the WOW.Com Content Network
The lobe separation angle (LSA, also called lobe centreline angle) is the angle between the centreline of the intake lobes and the centreline of the exhaust lobes. [23] A higher LSA reduces overlap, which improves idle quality and intake vacuum, [22] however using a wider LSA to compensate for excessive duration can reduce power and torque ...
Several key terms are relevant in such a construction of plate cams: base circle, prime circle (with radius equal to the sum of the follower radius and the base circle radius), pitch curve which is the radial curve traced out by applying the radial displacements away from the prime circle across all angles, and the lobe separation angle (LSA ...
The mechanism is a coaxial shaft arrangement where the outer shaft carries the main body of the cam lobe. The main body of the cam lobe is in its maximum duration form. Typically the main lobe body would have a duration of about 450°. The lobe is very long axially, about 45 mm (1.8 in), and its profile consists of conventional opening and ...
For twin-cam or DOHC engines, VCT was used on either the intake or exhaust camshaft. (Engines that have VCT on both camshafts are now designated as Ti-VCT.↓) The use of variable camshaft timing on the exhaust camshaft is for improved emissions, and vehicles with VCT on the exhaust camshaft do not require exhaust gas recirculation (EGR) as retarding the exhaust cam timing achieves the same ...
Oil under constant pressure is supplied to the lifter via an oil channel, through a small hole in the lifter body. When the engine valve is closed (lifter in a neutral position), the lifter is free to fill with oil. As the camshaft lobe enters the lift phase of its travel, it compresses the lifter piston, and a valve shuts the oil inlet.
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).
However, some high speed (in terms of engine RPM) motors now employ asymmetrical cam profiles in order to quickly open valves and set them back in their seats more gently to reduce wear. As well, production vehicles have employed asymmetrical cam lobe profiles since the late 1940s, as seen in the 1948 Ford V8. [7]
In an overhead valve engine the tappets (on right) are sandwiched between pushrods and the camshaft. In an internal combustion engine, a tappet (also called a 'valve lifter' or 'cam follower') [3] [4] [5] is the component which converts the rotation of the camshaft into vertical motion to open and close an intake or exhaust valve.
Ad
related to: camshaft lobe separation angle effects