enow.com Web Search

  1. Ads

    related to: high pressure water hammer arrestor for sprinkler system

Search results

  1. Results from the WOW.Com Content Network
  2. Water hammer - Wikipedia

    en.wikipedia.org/wiki/Water_hammer

    The following characteristics may reduce or eliminate water hammer: Reduce the pressure of the water supply to the building by fitting a regulator. Lower fluid velocities. To keep water hammer low, pipe-sizing charts for some applications recommend flow velocity at or below 1.5 m/s (4.9 ft/s). Fit slowly closing valves.

  3. Hydropneumatic device - Wikipedia

    en.wikipedia.org/wiki/Hydropneumatic_device

    Hydropneumatic water hammer preventers are chambers of sufficient volume to allow an extension of time in which a given flow may be accelerated or decelerated without sudden large change in pressure. See also expansion tank. When shock waves of an incompressible fluid within a piping system exist, especially at a high velocity, there is a high ...

  4. Backflow prevention device - Wikipedia

    en.wikipedia.org/wiki/Backflow_prevention_device

    In water distribution systems, water is normally maintained at a significant pressure to enable water to flow from the tap, shower, or other fixture. Water pressure may fail or be reduced when a water main bursts, pipes freeze, or there is unexpectedly high demand on the water system (for example, when several fire hydrants are opened).

  5. Fire hydrant - Wikipedia

    en.wikipedia.org/wiki/Fire_hydrant

    If a fire hydrant is opened or closed too quickly, a water hammer can occur and damage nearby pipes and equipment. The water inside a charged hose line causes it to be very heavy, and high-water pressure causes it to be stiff and unable to make a tight turn while pressurized. When a fire hydrant is unobstructed, this is not a problem, as there ...

  6. Fire pump - Wikipedia

    en.wikipedia.org/wiki/Fire_pump

    A jockey pump, also known as a pressure-maintenance pump, is a small pump connected to a fire suppression system near the fire pump and is intended to maintain pressure in a fire protection piping system. These pumps recover pressures lost from gradual, slow pressure declines in a system due to temperature changes, trapped air escapement, or ...

  7. Standpipe (firefighting) - Wikipedia

    en.wikipedia.org/wiki/Standpipe_(firefighting)

    External access point for fire sprinkler and dry standpipe at a building in San Francisco, US Antique wet standpipe preserved at Edison and Ford Winter Estates. A standpipe or riser is a type of rigid water piping which is built into multi-story buildings in a vertical position, or into bridges in a horizontal position, to which fire hoses can be connected, allowing manual application of water ...

  1. Ads

    related to: high pressure water hammer arrestor for sprinkler system