enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Furniture screw - Wikipedia

   en.wikipedia.org/wiki/Furniture_screw

   Insert nut, a type of en type of threaded insert for wood; Sex bolt, a type of nut with a low shoulder (flange) to provide resistance with little protrusion; T-nut, a nut that can be knocked into the back of a wood plate to provide a screw mounting hole; Wood hanger screw, a screw with machine threads in one end, and wood screw threads in the other

3. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Bits also differ by the diameter of their shank, with 1 ⁄ 2-inch, 12 mm, 10 mm, 3 ⁄ 8-inch, 8 mm and 1 ⁄ 4-inch and 6 mm shanks (ordered from thickest to thinnest) being the most common. Half-inch bits cost more but, being stiffer, are less prone to vibration (giving smoother cuts) and are less likely to break than the smaller sizes.

4. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

5. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.

6. Rough Cut with Fine Woodworking - Wikipedia

   en.wikipedia.org/.../Rough_Cut_with_Fine_Woodworking

   The show was originally known as Rough Cut: Woodworking with Tommy Mac and was hosted by Thomas J. MacDonald. [1] Presented as an instructional woodworking tutorial, Tommy Mac guided the viewer through the necessary steps to create tables, cabinets, chairs, and many more artisan woodworks.

7. Dutchman (repair) - Wikipedia

   en.wikipedia.org/wiki/Dutchman_(repair)

   A rail repair dutchman is typically a 4–6-inch (100–150 mm) long piece of rail that is cut in advance for the purpose and carried by a section crew. If the gang finds a rail with a chipped or broken end, they remove the connector plates ( fishplates ), cut out the damaged section, replace it with the dutchman, and bolt the connectors back ...