Ads
related to: manual motor switch with overloads
Search results
Results from the WOW.Com Content Network
A motor controller is a device or group of devices that can coordinate in a predetermined manner the performance of an electric motor. [1] A motor controller might include a manual or automatic means for starting and stopping the motor, selecting forward or reverse rotation, selecting and regulating the speed, regulating or limiting the torque, and protecting against overloads and electrical ...
Contactor with overload relay. A magnetic starter is an electromagnetically operated switch which provides a safe method for starting an electric motor with a large load. . Magnetic starters also provide under-voltage and overload protection and an automatic cutoff in the event of a power fai
Motor-loads for household appliances: examples: fans, central vacuum: 60947-4-1 61095 AC-8a: Hermetic refrigerant compressor motor control with manual resetting overloads: 60947-4-1 AC-8b: Hermetic refrigerant compressor motor control with automatic resetting overloads: 60947-4-1 AC-12
The thermal and magnetic overload detections are typically used together in a motor protection relay. [citation needed] Electronic overload protection relays measure motor current and can estimate motor winding temperature using a "thermal model" of the motor armature system that can be set to provide more accurate motor protection.
A small, early 1960s-vintage motor control center for 480 volt motors. A motor control center ( MCC ) is an assembly to control some or all electric motors in a central location. It consists of multiple enclosed sections having a common power bus and with each section containing a combination starter, which in turn consists of motor starter ...
Thermoswitches or PTC thermistors which are embedded in the motor windings mostly reliably fulfil this task. They trip when the temperature limit has been exceeded and the controls switch off the motor. The positioner [1] is supplied with a setpoint [2] and an actual value [3]. The motor is controlled until the actual value is identical to the ...
AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.
A Single-Pole, Single-Throw (SPST) mercury switch on millimetre graph paper, device length approximately 1.5 cm Another mercury switch design. A mercury switch is an electrical switch that opens and closes a circuit when a small amount of the liquid metal mercury connects metal electrodes to close the circuit.
Ads
related to: manual motor switch with overloads