enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Carbon monoxide (data page) - Wikipedia

    en.wikipedia.org/wiki/Carbon_monoxide_(data_page)

    Gas properties Std enthalpy change of formation, Δ f H o gas: −110.53 kJ/mol Std enthalpy change of combustion, Δ c H o gas: −283.0 kJ/mol Standard molar entropy, S o gas: 197.66 J/(mol K) Heat capacity, c p: 29 J/(mol K)

  3. Van der Waals constants (data page) - Wikipedia

    en.wikipedia.org/wiki/Van_der_Waals_constants...

    The following table lists the Van der Waals constants (from the Van der Waals equation) for a number of common gases and volatile liquids. [ 1 ] To convert from L 2 b a r / m o l 2 {\displaystyle \mathrm {L^{2}bar/mol^{2}} } to L 2 k P a / m o l 2 {\displaystyle \mathrm {L^{2}kPa/mol^{2}} } , multiply by 100.

  4. Carbon monoxide - Wikipedia

    en.wikipedia.org/wiki/Carbon_monoxide

    Carbon monoxide (chemical formula CO) is a poisonous, flammable gas that is colorless, odorless, tasteless, and slightly less dense than air. Carbon monoxide consists of one carbon atom and one oxygen atom connected by a triple bond. It is the simplest carbon oxide. In coordination complexes, the carbon monoxide ligand is called carbonyl. It is ...

  5. Mass diffusivity - Wikipedia

    en.wikipedia.org/wiki/Mass_diffusivity

    Carbon dioxide in air has a diffusion coefficient of 16 mm 2 /s, and in water its diffusion coefficient is 0.0016 mm 2 /s. [ 1 ] [ 2 ] Diffusivity has dimensions of length 2 / time, or m 2 /s in SI units and cm 2 /s in CGS units .

  6. Heat of combustion - Wikipedia

    en.wikipedia.org/wiki/Heat_of_combustion

    It is measured as a unit of energy per unit mass or volume of substance. The HHV is determined by bringing all the products of combustion back to the original pre-combustion temperature, including condensing any vapor produced. Such measurements often use a standard temperature of 25 °C (77 °F; 298 K) [citation needed].

  7. Vapour density - Wikipedia

    en.wikipedia.org/wiki/Vapour_density

    vapour density = molar mass of gas / molar mass of H 2 vapour density = molar mass of gas / 2.01568 vapour density = 1 ⁄ 2 × molar mass (and thus: molar mass = ~2 × vapour density) For example, vapour density of mixture of NO 2 and N 2 O 4 is 38.3. Vapour density is a dimensionless quantity. Vapour density = density of gas / density of ...

  8. The Best Place to Put a Carbon Monoxide Detector (and 5 ... - AOL

    www.aol.com/lifestyle/best-place-put-carbon...

    Make sure to install extra carbon monoxide detectors 5 to 20 feet from sources of CO gas, including the stove, dryer, or furnace, and follow the manufacturer's guidelines for specific ...

  9. Standard enthalpy of formation - Wikipedia

    en.wikipedia.org/wiki/Standard_enthalpy_of_formation

    Carbon: Gas C 716.67 Carbon dioxide: Gas CO 2: −393.509 Carbon disulfide: Liquid CS 2: 89.41 Carbon disulfide: Gas CS 2: 116.7 Carbon monoxide: Gas CO −110.525 Carbonyl chloride Gas COCl 2: −218.8 Carbon dioxide (un–ionized) Aqueous CO 2 (aq) −419.26 Bicarbonate ion Aqueous HCO 3 – −689.93 Carbonate ion Aqueous CO 3 2– −675.23 ...