enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The fitting is known as a reducing coupling, reducer, or adapter if their sizes differ. There are two types of collars: "regular" and "slip". A regular coupling has a small ridge or stops internally to prevent the over-insertion of a pipe and, thus, under-insertion of the other pipe segment (which would result in an unreliable connection).

3. Nipple (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Nipple_(plumbing)

   A chase nipple is a short pipe fitting, which creates a path for wires between two electrical boxes. A chase nipple has male threads on one end only. The other end is a hexagon. The chase nipple passes through the knockouts of two boxes, and is secured by an internally threaded ring called a lock nut. [1] [2]

4. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Pipe coupling (copper sweat) In piping and plumbing, a coupling (or coupler) is a very short length of pipe or tube, with a socket at one or both ends that allows two pipes or tubes to be joined, welded (), brazed or soldered (copper, brass etc.) together.

5. British Standard Pipe - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Pipe

   British Standard Pipe (BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external thread with an internal (female) thread.

6. Thermoplastic-sheathed cable - Wikipedia

   en.wikipedia.org/wiki/Thermoplastic-sheathed_cable

   4/1.5 mm 2 and 6/2.5 mm 2 have stranded conductors and a solid CPC (fixed high power equipment or sub-mains) 10/4 mm 2 and 16/6 mm 2 have stranded conductors and CPC (fixed high power equipment or sub-mains) In older properties (pre-1970) cable with imperial sizes are found, sometimes without CPC.

7. Engineering drawing abbreviations and symbols - Wikipedia

   en.wikipedia.org/wiki/Engineering_drawing...

   2. Near side: The drawing notations "near side" and "far side" tell the reader which side of the part a feature is on, in occasional contexts where that fact is not communicated using the rules of projection alone. Contexts of usage are rather limited. See "far side" for examples. NSCM: National Stock/Supply Code for Manufacturers