Search results
Results from the WOW.Com Content Network
Due to the higher density, diesel fuel offers a higher volumetric energy density: the density of EN 590 diesel fuel is defined as 0.820 to 0.845 kg/L (6.84 to 7.05 lb/US gal) at 15 °C (59 °F), about 9.0-13.9% more than EN 228 gasoline (petrol)'s 0.720–0.775 kg/L (6.01–6.47 lb/US gal) at 15 °C, which should be put into consideration when ...
Assuming the Emma Maersk consumes diesel (as opposed to fuel oil which would be the more precise fuel) then 1 kg diesel = 1.202 litres = 0.317 US gallons. This corresponds to 46,525 kJ. Assuming a standard 14 tonnes per container (per teu) this yields 74 kJ per tonne-km at a speed of 45 km/h (24 knots).
The gas price prior to reform was $0.10 US per liter with the quota of 100 liters per month per passenger car. The reform raised the price to $0.40 US per liter and later reduced the ration to 60 liters per month. The price for over-quota consumption and the imported cars were $0.70 US per liter.
Energy density by mass (MJ/kg) Energy density by volume (MJ/L) Peak recovery efficiency % Practical recovery efficiency % Notes This page was last edited on 5 ...
A diesel cycle engine can be as much as 40% to 50% efficient at converting fuel into work, [2] where a typical automotive gasoline engine's efficiency is about 25% to 30%. [3] [4] In general, an engine is designed to run on a single fuel source and substituting one fuel for another may affect the thermal efficiency.
In light-water reactors, 1 kg of natural uranium – following a corresponding enrichment and used for power generation– is equivalent to the energy content of nearly 10,000 kg of mineral oil or 14,000 kg of coal. [16] Comparatively, coal, gas, and petroleum are the current primary energy sources in the U.S. [17] but have a much lower energy ...
The top fundraising campaign on crowdfunding platform GoFundMe in 2024 reflects what has been a major pain point for millions of Americans: inflation.
The EN 590 had been introduced along with the European emission standards.With each of its revisions the EN 590 had been adapted to lower the sulphur content of diesel fuel – since 2007 this is called ultra-low-sulphur diesel as the former function of sulphur as a lubricant is absent (and needs to be replaced by additives).