Search results
Results from the WOW.Com Content Network
A serial interface is provided for programming, but no USB interface. Late versions of this board support Power over Ethernet (PoE). Arduino Fio [36] ATmega328P [27] 8 MHz minimal 66.0 mm × 27.9 mm [ 2.6 in × 1.1 in ] XBee Serial 3.3 V 32 1 2 14 6 8 March 18, 2010 [37] Includes XBee socket on bottom of board. [36] Arduino Nano [38] ATmega328 [33]
C Programming for Microcontrollers, a book for learning to program AVRs using C, was written for the Butterfly as development platform. [6] [7] The Butterfly Logger is an open source data logger based on the AVR Butterfly. [8] The Butteruino project is a set of libraries to integrate the AVR Butterfly with the Arduino development environment. [9]
A C/C++ library called libmaple is available to make it easier to migrate from Arduino. OLIMEXINO-STM32 board by Olimex has a STM32F103RBT6 microcontroller and similar to the Maple board. Netduino with support for .NET Micro Framework. ST Nucleo-64 and Nucleo-144 boards have female pin headers for Arduino shields too. (see Nucleo section below)
The Unified Program and Debug Interface (UPDI) is a one-wire interface for external programming and on-chip debugging of newer ATtiny and ATmega devices. UPDI chips can be programmed by an Atmel-ICE, a PICkit 4, an Arduino (flashed with jtag2updi), [ 19 ] or though a UART (with a 1 kΩ resistor between the TX and RX pins) controlled by ...
Possible elements of a video game joystick: 1. stick, 2. base, 3. trigger, 4. extra buttons, 5. autofire switch, 6. throttle, 7. hat switch (POV hat), 8. suction cups. A joystick, sometimes called a flight stick, is an input device consisting of a stick that pivots on a base and reports its angle or direction to the device it is controlling.
The interface devices are also defined with subclass descriptors. The subclass descriptor is used to declare a device bootable. A boot device meets a minimum adherence to a basic protocol and will be recognized by a computer's BIOS. Each USB HID interface communicates with the host using either a control pipe or an interrupt pipe.
Kempston joystick interface Kempston Interface plugged into a Spectrum Plus ZX Spectrum Kempston Joystick Interface with 3 ports and cartridge slot. The Kempston Interface is a joystick interface used on the ZX Spectrum series of computers that allows controllers complying with the de facto Atari joystick port standard (using the DE-9 connector) to be used with the machine.
A serial interface is provided for programming, but no USB interface. Late versions of this board support Power over Ethernet (PoE). Arduino Fio [30] Arduino Yes ATmega328P [21] 8 MHz minimal 2.6 in × 1.1 in [ 66.0 mm × 27.9 mm ] XBee Serial 3.3 V 32 1 2 14 6 8 March 18, 2010 [31] Includes XBee socket on bottom of board. [30] Arduino Nano [32]