Search results
Results from the WOW.Com Content Network
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used. [12]
Blocking placed as attachment points for cabinets, while doubling as bracing against compression of the studs. Blocking ( dwang , nog, noggin, and nogging) is the use of short pieces of dimensional lumber in wood framed construction to brace longer members or to provide grounds for fixings.
Steel studs are gaining popularity as a non-combustible alternative, especially for non load-bearing walls, and are required in some firewalls. In New Zealand, the required lumber size and spacing of wall studs are determined using NZS 3604 Timber-framed buildings table 8.2 for loadbearing walls and table 8.4 for non-loadbearing walls. [4]
The stud is simply a vertical two-by-four beam in the wall for structural support. And if you lost your stud finder in the moving boxes or simply don’t have one to begin with, these hacks will help.
Exterior walls [ edit ] Shiplap is either rough-sawn 25 mm (1 in) or milled 19 mm ( 3 ⁄ 4 in) pine or similarly inexpensive wood between 76 and 254 mm (3 and 10 in) wide with a 9.5–12.7 mm ( 3 ⁄ 8 – 1 ⁄ 2 in) rabbet on opposite sides of each edge. [ 1 ]
Shop staff were robbed at knifepoint during a "terrifying incident" that resulted in £80 being stolen, police have said. A man in his 20s has been arrested on suspicion of robbery in connection ...
The house featured in "Home Alone" has officially sold, seven months after it was put on the market and just in time for Christmas.. The 5-bedroom, 6-bathroom house located in Winnetka, Illinois ...
wall studs (subsidiary upright limbs in framed walls), for example, close studding. The horizontal timbers include: sill-beams (also called ground-sills or sole-pieces, at the bottom of a wall into which posts and studs are fitted using tenons), noggin-pieces (the horizontal timbers forming the tops and bottoms of the frames of infill panels),