Ads
related to: ranque hilsch vortex cooling tube for generator repair cost installed near meenglish.exair.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
The vortex tube, also known as the Ranque-Hilsch vortex tube, is a mechanical device that separates a compressed gas into hot and cold streams. The gas emerging from the hot end can reach temperatures of 200 °C (390 °F), and the gas emerging from the cold end can reach −50 °C (−60 °F). [ 1 ]
Georges-Joseph Ranque (7 February 1898 – 15 January 1973) was the inventor of the Ranque-Hilsch vortex tube, which generates streams of hot and cold gas from a stream of compressed gas. Georges-Joseph Ranque was born in Ambérieu-en-Bugey , France in 1898. [ 1 ]
A heat recovery steam generator (HRSG) is an energy recovery heat exchanger that recovers heat from a hot gas stream, such as a combustion turbine or other waste gas stream. It produces steam that can be used in a process ( cogeneration ) or used to drive a steam turbine ( combined cycle ).
Vortex generators are most often used to delay flow separation.To accomplish this they are often placed on the external surfaces of vehicles [4] and wind turbine blades. On both aircraft and wind turbine blades they are usually installed quite close to the leading edge of the aerofoil in order to maintain steady airflow over the control surfaces at the trailing edge. [3]
A run-around coil installation, serving air handling units on the roof of an office building. A run-around coil is a type of energy recovery heat exchanger most often positioned within the supply and exhaust air streams of an air handling system, or in the exhaust gases of an industrial process, to recover the heat energy. Generally, it refers ...
An automotive thermoelectric generator (ATEG) is a device that converts some of the waste heat of an internal combustion engine (IC) into electricity using the Seebeck Effect. A typical ATEG consists of four main elements: A hot-side heat exchanger , a cold-side heat exchanger, thermoelectric materials , and a compression assembly system.
The surface condenser is a shell and tube heat exchanger in which cooling water is circulated through the tubes. [ 10 ] [ 14 ] [ 15 ] [ 16 ] The exhaust steam from the low-pressure turbine enters the shell, where it is cooled and converted to condensate (water) by flowing over the tubes as shown in the adjacent diagram.
A surface condenser is a water-cooled shell and tube heat exchanger installed to condense exhaust steam from a steam turbine in thermal power stations. [ 1 ] [ 2 ] [ 3 ] These condensers are heat exchangers which convert steam from its gaseous to its liquid state at a pressure below atmospheric pressure .
Ads
related to: ranque hilsch vortex cooling tube for generator repair cost installed near meenglish.exair.com has been visited by 10K+ users in the past month